Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
18 Craftsman Inch and Metric Combination Wrenches
Fits (9) raised-panel, USA-made wrenches from 1/4 through 3/4, and (9) raised-panel, USA-made wrenches from 7 through 16 mm.
Caution: Only fits the older Craftsman wrenches marked "FORGED IN U.S.A." Newer Craftsman wrenches will not fit because they have larger heads and some length differences.
Drawer Size
22-1/4 X 10-5/8 inches
$35.00
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 18 Craftsman combination wrenches:
inch sizes:
1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 3/4 (left side)
metric wrenches:
7, 8, 10, 11, 12, 13, 14, 15, 16 (right side)
This tool organizer was designed to fit the older raised-panel wrenches which have "FORGED IN U.S.A." markings. Wrenches lacking this mark will not fit.
22-1/4 X 10-5/8 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 10-1/2 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.