Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
15 Craftsman Metric Flare-Nut and Ignition Wrenches
Fits (5) metric flare-nut wrenches,
and (10) metric ignition wrenches.
Note: This organizer fits the metric flare-nut and ignition wrenches from version 1 of the Craftsman 540-piece mechanics tool set 36540.
Caution: Only fits the older Craftsman wrenches marked "U.S.A." Newer Craftsman wrenches will not fit.
Drawer Size
11-1/2 X 16-1/4 inches
$29.30
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 15 Craftsman wrenches:
metric flare-nut wrenches:
9 X 11, 10 X 12, 13 X 14, 15 X 17, 16 X 18
metric ignition wrenches:
4, 4.5, 5, 5.5, 6, 7, 8, 9, 10, 11
This organizer fits the metric flare-nut and ignition wrenches included in version 1 of the Craftsman 540-piece mechanics tool set 36540. The pockets only fit older wrenches with "U.S.A." markings.
11-1/2 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 11 X 14 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.