Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
36 Craftsman Inch and Metric Combination Wrenches
Overview
36 Craftsman Inch and Metric Combination Wrenches
Fits (15) raised-panel combination wrenches from 1/4 to 1 inch plus 1-1/8 inch, and (21) raised-panel combination wrenches from 6 to 26 mm.
Note: This organizer fits the combination wrenches from version 1 of the Craftsman 540-piece mechanics tool set 36540.
Caution: Only fits the older Craftsman wrenches marked "U.S.A." Newer Craftsman wrenches will not fit.
Drawer Size
36-1/2 X 16-1/4 inches
$76.20
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 36 Craftsman wrenches:
inch sizes:
1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, 1, 1-1/8 (left side)
metric sizes:
6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, 25, 26 (right side)
This tool organizer was designed to fit the combination wrenches from version 1 of the Craftsman 540-pc mechanics tool set 36540. The pockets fit older raised-panel wrenches with "FORGED IN U.S.A." markings. Wrenches lacking this mark will not fit.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
36-1/2 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 36-1/4 X 16-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1X-00594.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
