Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
17 Craftsman Metric Combination Wrenches
Fits (17) raised-panel, USA-made wrenches from 6 through 22 mm.
Note: This organizer fits the metric combination wrenches from the Craftsman 300-piece basic essential pro set (see Craftsman 33300).
Caution: Only fits the older Craftsman wrenches marked "FORGED IN U.S.A." Newer Craftsman wrenches will not fit because they have larger heads and some length differences.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 17 Craftsman combination wrenches:
metric sizes:
6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22
This tool organizer was designed to fit the combination wrenches from the Craftsman 300-pc basic essentials pro set (33300). The pockets fit the older raised-panel wrenches which have "FORGED IN U.S.A." markings. Wrenches lacking this mark will not fit.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 22 X 14-1/2 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.