Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
92 Craftsman Sockets
Overview
92 Craftsman Sockets
Fits (43) inch sockets,
(47) metric sockets,
and (2) Torx bit sockets.
Accommodates all 1/2-drive sockets from the 413-piece mechanics tool set 33413.
Caution: Recommended for a 4-inch or deeper drawer.
Drawer Size
22-1/4 X 14-1/2 inches
$56.40
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 92 Craftsman sockets:
(11) 1/2-drive 6-point sizes from 3/8 to 1
(14) 1/2-drive 6-point sizes from 9 to 22
(6) 1/2-drive 8-point sizes from 7/16 to 3/4
(15) 1/2-drive 12-point sizes from 3/8 to 1-1/4
(21) 1/2-drive 12-point sizes from 9 to 27 plus 30 and 32
(9) 1/2-drive 12-point deep sizes from 1/2 to 1
(10) 1/2-drive 12-point deep sizes from 13 to 22
(2) 1/2-drive hex bit sizes 9/16 and 5/8
(2) 1/2-drive hex bit sizes 14 and 17
(2) 1/2-drive Torx bit sizes T55 and T60
This tool organizer was designed to fit the 1/2-drive sockets from the Craftsman 413-piece set 33413. The pockets are sized to fit sockets with "U.S.A." markings.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
22-1/4 X 14-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-1/2 X 14 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1A-00765.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
