Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
14 Craftsman Inch and Metric Nut Drivers
Fits (7) inch nut drivers and (7) metric nut drivers.
Drawer Size
11-1/2 X 16-1/4 inches
$29.30
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 14 Craftsman nut drivers:
inch: 3/16, 1/4, 5/16, 11/32, 3/8, 7/16, 1/2 (front row)
metric: 5, 6, 7, 8, 9, 10, 11 (back row)
The nut drivers are available as Craftsman 7-piece inch set 4196 and 7-piece metric set 4197. These nut drivers are also included in a variety of larger tool sets. The pockets are sized to fit nut drivers with or without "USA" markings.
11-1/2 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 11 X 15-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.