Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
24 Craftsman Screwdrivers and 14 Nut Drivers
Fits (11) slotted screwdrivers,
(7) Phillips screwdrivers,
(6) torx screwdrivers,
(7) inch nut drivers,
and (7) metric nut drivers.
Accommodates all screwdrivers and nut drivers from the 540-piece mechanics tool set 35540 or 36540.
Drawer Size
36-1/2 X 16-1/4 inches
$76.20
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 38 Craftsman screwdrivers and nut drivers:
slotted: 3/32 X 1-1/2, 1/8 X 2, 1/8 X 4, 3/16 X 4, 3/16 X 6, 3/16 X 8, 1/4 X 1-1/2, 1/4 X 4, 1/4 X 6, 5/16 X 2, 5/16 X 8
Phillips: P0 X 1-1/2, P0 X 2-1/2, P1 X 3, P2 X 1-1/2, P2 X 4, P2 X 8, P3 X 6
torx: T10, T15, T20, T25, T27, T30
inch nut drivers: 3/16, 1/4, 5/16, 11/32, 3/8, 7/16, 1/2
metric nut drivers: 5, 6, 7, 8, 9, 10, 11
This tool organizer was designed to fit all the screwdrivers and nut drivers from the 540-piece mechanics tool set 35540 or 36540.
36-1/2 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 36-1/8 X 15-7/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.