Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
6 Craftsman Pliers and 2 Snap Ring Pliers
Overview
6 Craftsman Pliers and 2 Snap Ring Pliers
Fits (6) pliers from set 45408,
and (2) retaining ring pliers from set 47387.
Drawer Size
22-1/4 X 10-5/8 inches
$35.00
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 8 Craftsman pliers:
8 inch duck bill (Craftsman 45087)
8 inch long nose (Craftsman 45103)
6 inch diagonal cutter (Craftsman 45075)
6-3/4 inch slip joint pliers (Craftsman 45378)
8 inch linesman (Craftsman 45094)
9-1/2 inch arc joint pliers (Craftsman 45381)
internal retaining ring pliers (Craftsman 47387I)
external retaining ring pliers (Craftsman 47387E)
The pliers listed above are available as Craftsman 6-piece set 45408 and Craftsman 2-piece set 47387.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
22-1/4 X 10-5/8 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 10-3/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1S-00906.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
