Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
64 Craftsman 1/4-drive Sockets with Magnetic Bit Set and 6 Screwdrivers
Fits (41) inch 1/4-drive sockets,
(23) metric 1/4-drive sockets,
(1) ratchet,
(3) extensions,
(1) spinner handle,
(1) magnetic handle,
(22) magnetic bits,
(3) slotted screwdrivers,
and (3) Phillips screwdrivers.
Accommodates the 1/4-drive sockets, drive tools, and screwdrivers from the 302-piece mechanics tool set 48302.
Drawer Size
22-1/4 X 14-1/2 inches
$43.00
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 64 Craftsman sockets and additional tools:
(11) 1/4-drive 6-point sizes from 5/32 to 9/16
(10) 1/4-drive 12-point sizes from 3/16 to 9/16
(10) 1/4-drive 6-point deep sizes from 3/16 to 9/16
(10) 1/4-drive 12-point deep sizes from 3/16 to 9/16
(12) 1/4-drive 6-point sizes from 4 to 14
(11) 1/4-drive 6-point deep sizes from 4 to 14
1/4-drive thin-profile ratchet (Craftsman 44994)
1-1/2-inch extension bar, 1/4-drive (Craftsman 43538)
3-inch extension bar, 1/4-drive (Craftsman 43539)
6-inch extension bar, 1/4-drive (Craftsman 43531)
1/4-drive spinner handle (Craftsman 43372)
magnetic handle (Craftsman 43373)
(7) inch nut driver bits
(5) metric nut driver bits
(9) screwdriver bits
(1) adapter bit for 1/4-drive sockets
1/8 X 4 screwdriver
3/16 X 4 screwdriver
1/4 X 6 screwdriver
P0 X 2-1/2 screwdriver
P1 X 3 screwdriver
P2 X 4 screwdriver
This tool organizer was designed to fit the 1/4-drive sockets, screwdrivers, and other tools from the Craftsman 302-piece set 48302. The pockets are sized to fit sockets that don't have "U.S.A." markings.
22-1/4 X 14-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 14-1/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.