Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
5 Craftsman Hammers with Pry Bar and 8 Punches
Fits (5) hammers,
(1) pry bar,
(7) punches,
and (1) chisel.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 5 Craftsman hammers and 9 additional tools:
8-oz ball pein hammer (Craftsman 38463)
16-oz ball pein hammer (Craftsman 38465)
12-oz plastic tip hammer (Craftsman 38292)
16-oz claw hammer (Craftsman 3821)
2-lb dead blow hammer (Craftsman 38394)
17 inch pry bar (Craftsman 43276)
1/16 X 4 pin punch (Craftsman 42881)
3/32 X 4 pin punch (Craftsman 42882)
1/8 X 4-1/2 pin punch (Craftsman 42883)
5/32 X 5 pin punch (Craftsman 42884)
3/8 X 4-1/2 center punch (Craftsman 42861)
3/8 X 4-1/2 prick punch (Craftsman 42841)
5/32 X 7 line up tool (Craftsman 42901)
1/2 X 5-3/4 cold chisel (Craftsman 42973)
The pin and alignment punches are available as Craftsman set 4285.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 15-3/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.