Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
15 Wright Inch Combination Wrench Set #1
Fits (15) inch combination wrenches from 1/4 through 1-1/8.
May be trimmed to fit a variety of drawer sizes.
Fits satin-finish or full-polish wrenches.
Drawer Size
24 X 18 inches
$52.20
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 15 Wright wrenches:
inch sizes:
1/4 (Wright 1108 or 1208)
5/16 (Wright 1110 or 1210)
3/8 (Wright 1112 or 1212)
7/16 (Wright 1114 or 1214)
1/2 (Wright 1116 or 1216)
9/16 (Wright 1118 or 1218)
5/8 (Wright 1120 or 1220)
11/16 (Wright 1122 or 1222)
3/4 (Wright 1124 or 1224)
13/16 (Wright 1126 or 1226)
7/8 (Wright 1128 or 1228)
15/16 (Wright 1130 or 1230)
1 (Wright 1132 or 1232)
1-1/16 (Wright 1134 or 1234)
1-1/8 (Wright 1136 or 1236)
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches. It may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 22 X 16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.