Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
7 Craftsman Large Full-Polish Combination Wrenches with Hex Keys, Fits non-USA Wrenches
Overview
7 Craftsman Large Full-Polish Combination Wrenches with Hex Keys, Fits non-USA Wrenches
Fits (4) full-polish inch combination wrenches,
(20) inch hex keys in pouch,
(3) full-polish metric combination wrenches,
and (20) metric hex keys in pouch.
Accommodates the combination wrenches and hex keys from the Craftsman 348-piece set 49348.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 7 Craftsman combination wrenches and 40 hex keys:
inch long-pattern combination wrenches:
13/16 (Craftsman 45982)
7/8 (Craftsman 45983)
15/16 (Craftsman 45984)
1 (Craftsman 45985)
metric long-pattern combination wrenches:
17 (Craftsman 45966)
18 (Craftsman 45997)
19 (Craftsman 45998)
(20) inch hex key set (Craftsman 46696)
(20) metric hex key set (Craftsman 46677)
This tool organizer was designed to fit the inch and metric combination wrenches from the Craftsman 348-piece set 49348 with pockets for two pouches of hex keys. The wrench pockets are sized to only fit the full-polish, long-pattern wrenches that don't have "USA" markings.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-1/2 X 16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1M-01459.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
