Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
22 Wright Screwdrivers and Nut Drivers
Overview
22 Wright Screwdrivers and Nut Drivers
Fits (6) slotted screwdrivers, (6) Phillips screwdrivers, (5) inch nut drivers, (5) metric nut drivers.
May be trimmed to fit a variety of drawer sizes.
Drawer Size
24 X 18 inches
$52.20
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 22 Wright screwdrivers and nut drivers:
Slotted screwdrivers:
1/8 X 3 (Wright 9112)
3/16 X 4 (Wright 9115)
1/4 X 1-1/2 (Wright 9122)
1/4 X 6 (Wright 9124)
5/16 X 6 (Wright 9125)
3/8 X 8 (Wright 9135)
Phillips screwdrivers:
P0 X 3 (Wright 9103)
P1 X 3 (Wright 9104)
P2 X 1-1/2 (Wright 9101)
P2 X 4 (Wright 9105)
P2 X 8 (Wright 9108)
P3 X 6 (Wright 9106)
inch nut drivers:
1/4 (Wright 9222)
5/16 (Wright 9224)
11/32 (Wright 9225)
3/8 (Wright 9226)
7/16 (Wright 9227)
metric nut drivers:
5 mm (Wright 9238)
6 mm (Wright 9240)
7 mm (Wright 9241)
8 mm (Wright 9242)
10 mm (Wright 9244)
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 22-1/4 X 16-1/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1A-01524.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
