Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
5 Craftsman Extreme Grip Wrenches and 2 Locking Adjustable Wrenches
Overview
5 Craftsman Extreme Grip Wrenches and 2 Locking Adjustable Wrenches
Fits (5) extreme grip style wrenches and (2) locking adjustable wrenches.
Accommodates the extreme grip style wrenches from the Craftsman 903-pc set 21470.
Drawer Size
11-1/2 X 16-1/4 inches
$29.30
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 7 Craftsman wrenches:
3/8, 10mm extreme grip wrench (Craftsman 12759)
7/16, 11mm extreme grip wrench (Craftsman 15415)
1/2, 12mm, or 13mm extreme grip wrench (Craftsman 12760)
9/16, 14mm extreme grip wrench (Craftsman 12761)
5/8, 15mm, or 16mm extreme grip wrench (Craftsman 12762)
8-inch extreme grip locking adjustable wrench (Craftsman 42354)
10-inch extreme grip locking adjustable wrench (Craftsman 13272)
This tool organizer was designed to fit the extreme grip style wrenches from the Craftsman 903-pc set 21470.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
11-1/2 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 10-3/4 X 15-3/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1S-02077.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
