Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
10 Channellock Pliers Including 526 Slip Joint
Overview
10 Channellock Pliers Including 526 Slip Joint
Fits (10) Channellock pliers.
May be trimmed to fit a variety of drawer sizes.
Similar to F-02600-R with smaller slip joint pliers and excluding 8-inch long nose.
Drawer Size
24 X 18 inches
$52.20
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 10 Channellock pliers:
9.5-inch crimping pliers (Channellock 909)
7-inch cutting (diagonal) pliers (Channellock 437)
7.5-inch lineman's pliers (Channellock 367)
6.5-inch slip joint pliers (Channellock 526)
6-inch long nose pliers (Channellock E326)
8-inch bent nose pliers with cutter (Channellock E388)
8-inch long reach (duckbill) pliers (Channellock 718)
9.5-inch tongue and groove pliers (Channellock 420)
7-inch wire stripper for 10-20 AWG (Channellock 957)
8-inch retaining ring pliers (Channellock 927)
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 13-3/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-02842-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
