Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
11 Snap-on Instinct Slotted Screwdrivers with Ratcheting Screwdriver Set
Fits 11 flat-tip screwdrivers including (5) standard, (4) cabinet, and (2) mini-tip. Also fits (1) ratcheting handle with (2) magnetic holders and (5) bits.
Fits screwdrivers from 4 popular sets when used with F-02849-R.
Drawer Size
14-1/2 X 21-7/8 inches
$42.60
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 19 Snap-on screwdrivers, holders, and bits:
Slotted Mini-Tip:
1/8 X 3 (Snap-on SGD304B)
3/16 X 3 (Snap-on SGD306B)
Slotted Stubby:
1/4 X 1-7/8 (Snap-on SHD1)
Slotted Standard:
7/32 X 3 (Snap-on SGD2B)
1/4 X 4 (Snap-on SGD4B)
5/16 X 6 (Snap-on SGD6B)
3/8 X 8 (Snap-on SGD8B)
Slotted Cabinet:
3/16 X 6 (Snap-on SGD146B)
7/32 X 8 (Snap-on SGD480B)
7/32 X 12 (Snap-on SGD4120B)
7/32 X 16 (Snap-on SGD4160B)
Ratcheting Set SGDMRC103A:
Ratcheting Handle (Snap-on SGDMRC4A)
4-inch Magnetic Shank/Bit Holder (Snap-on SGDMRC4-40)
8-inch Magnetic Shank/Bit Holder (Snap-on SGDMRC4-80)
3/16 Flat-Tip Bit (Snap-on SDM211B)
9/32 Flat-Tip Bit (Snap-on SDM213B)
P1 Bit (Snap-on SDM221IRB)
P2 Bit (Snap-on SDM222IRB)
T15 Bit (Snap-on SDMT15B)
This tool organizer was designed to fit Snap-on Instinct screwdrivers. Accommodates the flat-tip screwdrivers from standard set SGDX80B, cabinet set SGDXL80B, mini-tip set SGDX40B, and 8 pieces from ratcheting set SGDMRC103A.
14-1/2 X 21-7/8 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 14 X 21-11/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.