Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
13 GearWrench Inch Non-Reversible Ratcheting Wrenches
Overview
13 GearWrench Inch Non-Reversible Ratcheting Wrenches
Fits (13) ratcheting wrenches from 1/4 to 1 inch.
Accommodates the wrenches from GearWrench set 9312.
Caution: Only fits wrenches without reversing levers.
Drawer Size
24 X 18 inches
$52.20
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 13 GearWrench wrenches:
inch sizes:
1/4 (GearWrench 9008)
5/16 (GearWrench 9010D)
3/8 (GearWrench 9012D)
7/16 (GearWrench 9014)
1/2 (GearWrench 9016D)
9/16 (GearWrench 9018D)
5/8 (GearWrench 9020)
11/16 (GearWrench 9022)
3/4 (GearWrench 9024)
13/16 (GearWrench 9026D)
7/8 (GearWrench 9028D)
15/16 (GearWrench 9030)
1 (GearWrench 9032)
This tool organizer was designed to fit non-reversible ratcheting wrenches from the GearWrench 13-piece set 9312. The pockets are sized to fit wrenches without reversing levers.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-5/8 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03095-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
