Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
16 GearWrench Metric Non-Reversible Ratcheting Wrenches
Fits (16) metric ratcheting wrenches from 8 to 22 plus 24mm.
Accommodates the wrenches from GearWrench set 9416.
Caution: Only fits wrenches without reversing levers.
Drawer Size
24 X 18 inches
$52.20
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 16 GearWrench wrenches:
8 (GearWrench 9108D)
9 (GearWrench 9109)
10 (GearWrench 9110D)
11 (GearWrench 9111)
12 (GearWrench 9112)
13 (GearWrench 9113D)
14 (GearWrench 9114D)
15 (GearWrench 9115D)
16 (GearWrench 9116D)
17 (GearWrench 9117D)
18 (GearWrench 9118D)
19 (GearWrench 9119)
20 (GearWrench 9120)
21 (GearWrench 9121)
22 (GearWrench 9122)
24 (GearWrench 9124)
This tool organizer was designed to fit non-reversible ratcheting wrenches from the GearWrench 16-piece set 9416. The pockets are sized to fit wrenches without reversing levers.
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 15-3/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.