Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
14 Tekton Nut Driver Set
Fits (7) inch and (7) metric nut drivers from set 26984.
May be trimmed to fit a variety of drawer sizes.
Drawer Size
24 X 18 inches
$52.20
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 14 Tekton nut drivers:
inch sizes:
3/16 (Tekton 26862)
1/4 (Tekton 26863)
5/16 (Tekton 26864)
11/32 (Tekton 26865)
3/8 (Tekton 26866)
7/16 (Tekton 26867)
1/2 (Tekton 26868)
metric sizes:
5mm (Tekton 26882)
5.5mm (Tekton 26883)
6mm (Tekton 26884)
7mm (Tekton 26885)
8mm (Tekton 26886)
9mm (Tekton 26887)
10mm (Tekton 26888)
This organizer was designed to fit Tekton nut drivers. See Tekton set 26984, or 26964 and 26974.
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 17-3/4 X 14-1/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.