FoamFit Tools section divider

Foam Tool Organizer for
11 Tekton Pliers with Tin Snips

see all organizers for Tekton

Overview

11 Tekton Pliers with Tin Snips

Fits (4) pliers, (4) mini pliers, (2) locking pliers, wire stripper, and tin snips.

May be trimmed to fit a variety of drawer sizes.

New!

Drawer Size
24 X 18 inches

$52.20



FoamFit Tools section divider

Details

This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following Tekton pliers:

7 inch wire stripper (Tekton 3797)
7 inch long nose pliers (Tekton PGF10007)
6-1/2 inch slip joint pliers (Tekton 37122)
7 inch diagonal cutting pliers (Tekton PCT00007)
10 inch groove joint pliers (Tekton 37524)
10 inch curved jaw locking pliers (Tekton PLK10010)
6 inch long nose locking pliers (Tekton PLK30006)
mini long nose pliers (Tekton PMN11001)
mini flat nose pliers (Tekton PMN21001)
mini diagonal cutting pliers (Tekton PMN54001)
mini bent long nose pliers (Tekton PMN11301)
10 inch straight pattern tin snips (Tekton 35104)

This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.



Made in the USA!

Foam Organizer for 9 Tekton Pliers and 2 Tekton Locking Pliers Plus a Tin Snips

note: tools are not included

Drawer Size

This organizer is designed to fit a toolbox drawer with inner dimensions of:

24 X 18 inches (inside width by inside depth)

It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 20-5/8 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.

Drawing

Please verify this organizer fits your tools before placing an order.

  1. Download the drawing: www.FoamFitTools.com/product/F-03394-R.pdf
  2. Print the pages of the drawing full size or 100% (not fit).
  3. Check that the printout is full size by measuring the border with a ruler.
  4. Assemble the pages and place the printed drawing in your toolbox drawer.
  5. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site