Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
26 Husky Inch Crow Foot, Midget, and Flare-Nut Wrenches
Fits (11) inch crow foot wrenches, (5) inch flare-nut wrenches, and (10) midget wrenches.
Accommodates the inch crow foot wrenches, flare-nut wrenches, and midget wrenches from the Husky 1025-pc set H1025MTS.
Drawer Size
12-5/8 X 18-1/2 inches
$34.70
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 26 Husky wrenches:
crow foot wrenches:
3/8-drive 3/8
3/8-drive 7/16
3/8-drive 1/2
3/8-drive 9/16
3/8-drive 5/8
3/8-drive 11/16
3/8-drive 3/4
3/8-drive 13/16
3/8-drive 7/8
3/8-drive 15/16
3/8-drive 1
flare-nut wrenches:
1/4 X 5/16
3/8 X 7/16 (HFNW71638)
1/2 X 9/16 (HFNW91612)
5/8 X 11/16 (HFNW111658)
3/4 X 7/8
midget wrenches:
5/32
3/16
7/32
1/4
9/32
13/64
15/64
5/16
3/8
7/16
This organizer was designed to fit the inch crow foot, flare-nut, and midget wrenches from the Husky 1025-pc set H1025MTS.
12-5/8 X 18-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 11-1/2 X 17-3/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.