3 Craftsman Gunmetal Ratchets with 96 Additional Tools
Fits (3) ratchets, (13) drive accesories, (39) bits, and (44) hex keys.
Accommodates ratches and drive tools from the Craftsman 282-piece gunmetal chrome mechanics tool set CMMT45282.
22-1/4 X 16-1/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 99 Craftsman ratchets and additional tools:
1-4-drive spinner handle (Craftsman 83-440)
1/4-drive 120-tooth pear head ratchet (Craftsman 82-010)
3/8-drive 120-tooth pear head ratchet (Craftsman 82-011)
1/2-drive 120-tooth pear head ratchet (Craftsman 82-012)
3-inch extension bar, 1/4-drive (Craftsman 82-021)
6-inch extension bar, 1/4-drive (Craftsman 82-022)
3-inch extension bar, 3/8-drive (Craftsman 82-024)
6-inch extension bar, 3/8-drive (Craftsman 82-025)
2.5-inch extension bar, 1/2-drive (Craftsman 82-027)
5-inch extension bar, 1/2-drive (Craftsman 82-028)
1/4-drive universal joint (Craftsman 82-014)
3/8-drive universal joint (Craftsman 82-015)
1/2-drive universal joint (Craftsman 82-016)
3/8-drive to 1/4 socket adapter (Craftsman 82-018)
1/2-drive to 3/8 socket adapter (Craftsman 82-020)
1/4-drive to 1/4 hex bit adapter (Craftsman 81-872)
(22) screwdriver bits in two holders
(14) hex keys from 3/64 to 5/16 in holder
(14) hex keys from 1.5 to 7 mm in holder
(8) short arm hex keys from 1/16 to 1/4 in holder
(8) short arm hex keys from 1.5 to 6 mm in holder
(8) nut driver bits from 3/16 to 1/2 in
(9) nut driver bits from 4 to 12mm
This tool organizer was designed to fit the ratchets, drive accessories, bits, and hex keys from the Craftsman 282-pc gunmetal chrome set CMMT45282.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 13-1/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.