Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
24 Eklind Inch Hex Keys
Fits (13) hex keys in holders and (11) T-handle hex keys.
Shown with Eklind hex key sets 13213 and Power-T set 60811.
Sized to fit long-version L-key sets and 9-inch Power-T sets. Additional sets with regular ends, ball ends, and bright finish may also be used.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 24 Eklind Hex Keys:
T-handle hex keys:
5/64, 3/32, 7/64, 1/8 , 9/64, 5/32, 3/16, 7/32, 1/4 , 5/16, 3/8
long hex keys in holder:
.050, 1/16, 5/64, 3/32, 7/64, 1/8 , 9/64, 5/32, 3/16, 7/32, 1/4 , 5/16, 3/8
This tool organizer was designed to fit long hex-L keys and 9-inch Power-T hex keys. Shown with Eklind sets 60811 and 13213.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-5/8 X 14-3/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.