Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
84 Tekton 1/2-drive Impact Sockets and 3 Drive Tools
Overview
84 Tekton 1/2-drive Impact Sockets and 3 Drive Tools
Fits (34) 1/2-drive inch impact sockets and (50) 1/2-drive metric impact sockets and (3) drive tools.
Accommodates the tools from the 87-pc Tekton set SID92407.
Caution: recommended for a 3-9/16 inch or deeper drawer.
Drawer Size
24 X 18 inches
$69.10
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 87 Tekton tools:
(17) 1/2-drive 6-point sizes from 5/16 to 1-1/4 in
(17) 1/2-drive 6-point deep sizes from 5/16 to 1-1/4 in
(25) 1/2-drive 6-point sizes from 8 to 32 mm
(25) 1/2-drive 6-point deep sizes from 8 to 32 mm
1/2 X 3 impact extension (Tekton SIA21103)
1/2 X 10 impact extension (Tekton SIA21100)
1/2 -drive impact universal joint (Tekton SIA22102)
This tool organizer was designed to fit the Tekton 87-pc, 1/2-drive impact socket set SID92407.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 14-13/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03833-T.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
