Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
14 Craftsman T-handle Hex Keys with 33 Additional Hex Keys
Overview
14 Craftsman T-handle Hex Keys with 33 Additional Hex Keys
Fits (7) inch T-handle hex keys, (7) metric T-handle hex keys, (17) hex keys in folding sets, and (16) short hex keys in holders.
Accommodates the hex keys from the 543-pc mechanics set CMMT72000.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 47 Craftsman tools:
T-through handle hex keys:
3/32, 7/64, 1/8, 5/32, 3/16, 7/32, 1/4
2.5, 3, 4, 5, 6, 8, 10 mm
folding hex key sets:
9-pc inch folding hex key set
9-pc metric folding hex key set
8-pc short inch L-key set in holder
8-pc short metric L-key set in holder
This tool organizer was designed to fit most of the hex keys from the Craftsman 543-pc set CMMT72000. It only fits the T-through handle hex keys that have black and red handles with a pattern of diagonal markings.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-04078-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
