Home | About | FAQ | Shipping Policies | Extras and Deals | Custom Options | Contact Us
14 Craftsman Pliers with Black and Red Handles
Fits (3) pliers, (3) groove joint pliers, (6) mini, and (2) locking pliers.
Accommodates the pliers from the 543-pc mechanics set CMMT72000.
Only fits the black and red handle tools sold by Lowes and other Craftsman dealers starting mid 2018.
Does not fit the black and red handle screwdrivers or TruGrip pliers sold by Sears.
Drawer Size
22-1/4 X 16-1/4 inches
$46.50
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 14 Craftsman tools:
6-inch slip-joint pliers (Craftsman CMHT81712)
6-inch diagonal cutter (Craftsman CMHT81646)
8-inch long nose pliers (Craftsman CMHT81645)
10-inch groove joint pliers (Craftsman CMHT81720)
12-inch groove joint pliers (Craftsman CMHT81721)
7-inch straight jaw locking pliers (Craftsman CMHT81725)
10-inch curved jaw locking pliers (Craftsman CMHT81726)
mini linesman pliers
mini diagonal cutter
mini end nipper
mini long nose pliers
mini bent nose pliers
mini needle nose pliers
This tool organizer was designed to fit all the pliers from the Craftsman 543-pc set CMMT72000. This newer generation of Craftsman pliers has black and red handles and some are marked with part numbers that start with "CMMT". Ten of these pliers are also available in smaller sets (CMHT82547, CMHT81716, and CMHT81727). This organizer does not fit the pliers with black and red handles sold by Sears.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.